Check to make sure the refresh rate on your PC is set between 60 Hz and 75 Hz. It is also recommended that
you use the AC Adapter, if a laptop is used.
Articles in this section
- Flash-dependent Web GUI features on legacy models are no longer supported
- Photon Go - ML1080UST - Pairing the Remote Control
- Photon Go - ML1080UST - Bootup Sequence
- Photon Go - ML1080UST - Best practice for shutting unit off at night/when not in use for extended period
- Understanding Key Projector Specifications Before Setup
- How to Power and Charge Your Photon Go Using USB-C PD Chargers and Portable Battery Packs
- How to Register Your Optoma product warranty for a Projector or Interactive Flat Panel (U.S, CAN)
- How to connect to Optoma Projector Webpage to access Projector settings including control
- Software and apps
- UHZ66: How to Enable or Disable HDR
- See more