Check to see if the lamp is properly in place.
Refer to the lamp installation procedure in your user guide and re-install the lamp.
The lamp may need to be replaced.
Articles in this section
- Flash-dependent Web GUI features on legacy models are no longer supported
- Photon Go - ML1080UST - Pairing the Remote Control
- Photon Go - ML1080UST - Bootup Sequence
- Photon Go - ML1080UST - Best practice for shutting unit off at night/when not in use for extended period
- Understanding Key Projector Specifications Before Setup
- How to Power and Charge Your Photon Go Using USB-C PD Chargers and Portable Battery Packs
- How to Register Your Optoma product warranty for a Projector or Interactive Flat Panel (U.S, CAN)
- How to connect to Optoma Projector Webpage to access Projector settings including control
- Software and apps
- UHZ66: How to Enable or Disable HDR
- See more